Tools For Ceramics
Karnasch has developed an individual range of tools for any challenges of ceramic machining. In addition to solid carbide end mills, solid carbide drills, solid carbide taps, whirling thread cutters, solid carbide thread mills and solid carbide deburrers, our microtools are also available for processing up to the very finest detail.
114081_P
The most widely used simple cutting style results, high cutting action with good surface finish for use.
From €13.10 Excl VAT
114082_P
The most widely used simple cutting style results, high cutting action with good surface finish for use.
From €12.85 Excl VAT
114083_P
The most widely used simple cutting style results, high cutting action with good surface finish for use.
From €20.70 Excl VAT
114085_P
The most widely used simple cutting style. High quality cutting action with good surface finish for use on all ferrous materials such as cast iron, steel less than 60 hrc, stainless steel, inox nickel basis and titanium alloy, also cooper, brass, bronze.
From €12.95 Excl VAT
116081_P
The most widely used simple cutting style results, high cutting action with good surface finish for use.
From €20.40 Excl VAT
116082_P
The most widely used simple cutting style results, high cutting action with good surface finish for use.
From €28.30 Excl VAT
116083_P
The most widely used simple cutting style results, high cutting action with good surface finish for use.
From €14.30 Excl VAT
116085_P
The most widely used simple cutting style. High quality cutting action with good surface finish for use on all ferrous materials such as cast iron, steel less than 60 hrc, stainless steel, inox nickel basis and titanium alloy, also cooper, brass, bronze.
From €28.50 Excl VAT
211500_P
Excellent for use in abrasive and very hard materials such as glass, fiber-glass and carbon-reinforced plastics, ceramics, stone, porcelain, brick and masonry. Heavy design with solid base plate for extra stability and best concentricity. Available in diameter 14-152mm.
From €11.35 Excl VAT
211510_P
Due to the 8,5 mm shank these hole saws can be used on all conventional drilling machines. Suitable for dry and for wet cutting (cooling with water recommended). All holw saws with diameter of 5-14 mm with a special cooling wax filling.
From €14.35 Excl VAT
113033_P
Extremly fine simple cutting style. Excellent surface finish. Preferred for fine deburring all ferrous materials such as up to extra hard steel ca. 70 hrc, cast iron, stainless steel, inox ,heat resistant substances, such as e.g. Nickel based + cobalt.
From €5.70 Excl VAT
113032_P
Extra fine cross cutting style excellent control for difficult to reach positions smooth operation short chips good surface finish medium cutting action for all kinds of steel, up to extra hard steel ca. 70 hrc cast iron stainless steel inox, etc.
From €6.55 Excl VAT